Abstract: The Maritime Aerosol Network (MAN) has been collecting data over the oceans since November 2006. Over 80 cruises were completed through early 2010 with deployments continuing. Measurement areas included various parts of the Atlantic Ocean, the Northern and Southern Pacific Ocean, the South Indian Ocean, the Southern Ocean, the Arctic Ocean and inland seas. MAN deploys Microtops handheld sunphotometers and utilizes a calibration procedure and data processing traceable to AERONET. Data collection included areas that previously had no aerosol optical depth (AOD) coverage at all, particularly vast areas of the Southern Ocean. The MAN data archive provides a valuable resource for aerosol studies in maritime environments. In the current paper we present results of AOD measurements over the oceans, and make a comparison with satellite AOD retrievals and model simulations.

Abstract: This Paper Reports On Consolidated Ground-based Validation Results Of The Atmospheric No2 Data Produced Operationally Since April 2018 By The Tropospheric Monitoring Instrument (Tropomi) On Board Of The Esa/eu Copernicus Sentinel-5 Precursor (S5p) Satellite. Tropospheric, Stratospheric, And Total No2 Column Data From S5p Are Compared To Correlative Measurements Collected From, Respectively, 19 Multi-axis Differential Optical Absorption Spectroscopy (Max-doas), 26 Network For The Detection Of Atmospheric Composition Change (Ndacc) Zenith-scattered-light Doas (Zsl-doas), And 25 Pandonia Global Network (Pgn)/pandora Instruments Distributed Globally. The Validation Methodology Gives Special Care To Minimizing Mismatch Errors Due To Imperfect Spatio-temporal Co-location Of The Satellite And Correlative Data, E.g. By Using Tailored Observation Operators To Account For Differences In Smoothing And In Sampling Of Atmospheric Structures And Variability And Photochemical Modelling To Reduce Diurnal Cycle Effects. Compared To The Ground-based Measurements, S5p Data Show, On Average, (I) A Negative Bias For The Tropospheric Column Data, Of Typically ?23 % To ?37 % In Clean To Slightly Polluted Conditions But Reaching Values As High As ?51 % Over Highly Polluted Areas; (Ii) A Slight Negative Median Difference For The Stratospheric Column Data, Of About ?0.2 Pmolec Cm?2, I.e. Approx. ?2 % In Summer To ?15 % In Winter; And (Iii) A Bias Ranging From Zero To ?50 % For The Total Column Data, Found To Depend On The Amplitude Of The Total No2 Column, With Small To Slightly Positive Bias Values For Columns Below 6 Pmolec Cm?2 And Negative Values Above. The Dispersion Between S5p And Correlative Measurements Contains Mostly Random Components, Which Remain Within Mission Requirements For The Stratospheric Column Data (0.5 Pmolec Cm?2) But Exceed Those For The Tropospheric Column Data (0.7 Pmolec Cm?2). While A Part Of The Biases And Dispersion May Be Due To Representativeness Differences Such As Different Area Averaging And Measurement Times, It Is Known That Errors In The S5p Tropospheric Columns Exist Due To Shortcomings In The (Horizontally Coarse) A Priori Profile Representation In The Tm5-mp Chemical Transport Model Used In The S5p Retrieval And, To A Lesser Extent, To The Treatment Of Cloud Effects And Aerosols. Although Considerable Differences (Up To 2 Pmolec Cm?2 And More) Are Observed At Single Ground-pixel Level, The Near-real-time (Nrti) And Offline (Offl) Versions Of The S5p No2 Operational Data Processor Provide Similar No2 Column Values And Validation Results When Globally Averaged, With The Nrti Values Being On Average 0.79 % Larger Than The Offl Values.

Abstract: This study deals with the problem of identifying atmospheric data influenced by local emissions that can result in spikes in time series of greenhouse gases and long-lived tracer measurements. We considered three spike detection methods known as coefficient of variation (COV), robust extraction of baseline signal (REBS) and standard deviation of the background (SD) to detect and filter positive spikes in continuous greenhouse gas time series from four monitoring stations representative of the European ICOS (Integrated Carbon Observation System) Research Infrastructure network. The results of the different methods are compared to each other and against a manual detection performed by station managers. Four stations were selected as test cases to apply the spike detection methods: a continental rural tower of 100?m height in eastern France (OPE), a high-mountain observatory in the south-west of France (PDM), a regional marine background site in Crete (FKL) and a marine clean-air background site in the Southern Hemisphere on Amsterdam Island (AMS). This selection allows us to address spike detection problems in time series with different variability. Two years of continuous measurements of CO2, CH4 and CO were analysed. All methods were found to be able to detect short-term spikes (lasting from a few seconds to a few minutes) in the time series. Analysis of the results of each method leads us to exclude the COV method due to the requirement to arbitrarily specify an a priori percentage of rejected data in the time series, which may over- or underestimate the actual number of spikes. The two other methods freely determine the number of spikes for a given set of parameters, and the values of these parameters were calibrated to provide the best match with spikes known to reflect local emissions episodes that are well documented by the station managers. More than 96?% of the spikes manually identified by station managers were successfully detected both in the SD and the REBS methods after the best adjustment of parameter values. At PDM, measurements made by two analyzers located 200?m from each other allow us to confirm that the CH4 spikes identified in one of the time series but not in the other correspond to a local source from a sewage treatment facility in one of the observatory buildings. From this experiment, we also found that the REBS method underestimates the number of positive anomalies in the CH4 data caused by local sewage emissions. As a conclusion, we recommend the use of the SD method, which also appears to be the easiest one to implement in automatic data processing, used for the operational filtering of spikes in greenhouse gases time series at global and regional monitoring stations of networks like that of the ICOS atmosphere network.